Home > News > Content
Solar Stud Common Problems
Dec 19, 2014

Anti-pressure value failed

Products installed on the road, there is a problem with the pressure, the product is either crushed or up and down.

Separation, this is actually caused by the irrational structure, the main performance of the unreasonable structure:

1, hollow inside, hollow pressure.

The internal hollow hazard is also reflected in the LED lamp shade, which is damaged due to hollowness, and then the LED itself will be damaged.

Detection method:

After the white board is pulled out, the steel ball falls freely at a height of one meter and vertically impacts the portion of the solar spike LED lamp shade. Look at its lampshade is not bad.

2. Wrong nail structure

Solar pin with nails is divided into two parts. The lower part is the base part with nails, the upper part is the solar panel, led part and lampshade part. The upper part and the lower part are connected by several screws. Most of the nailed solar studs until 2014 All use this structure. When the product is installed on the road surface and fixed with glue, only the lower half of the solar power spike is actually fixed and adhered, and the upper half is fixed to the lower part only by a few small screws.

The most common problem with spiked solar spikes is the separation between the upper and lower parts. During the rolling process of the vehicle, several screws are too thin, the power is too small, the car is pressed for several times, and the top part flies away.

led cats eyes solar road studs .jpg

The stabilizing, spikeless solar studs without spikes, the spikes are glued to the ground, spikes with studs, and the top is affixed to the ground with several small screws.

False reflection

The first countries to make solar spikes active and passively emit light are Japanese and Korean companies. Their requirements for solar spikes are: If for any reason, the solar spikes cannot work, they can be compensated by the reflective spikes.

Authentic reflective cores are electroformed on a needle-type electroforming mother board. The accuracy is very high. After the mother board is used several times, it must be removed and reground to ensure the reflection of the reflective core. There are only a few companies in the world that can make such pin-type motherboards. Some domestic small-sized electroforming and converting plants do not have the ability to use the pin-type motherboards to cast them. This creates a product that looks like a reflective film and is actually not reflective.

Reflective film identification method:

Place the solar spikes 10 meters away, hold a small flashlight in your hand, and place the flashlight between your eyes. Light is applied to the surface of the product to see if it reflects light.

Intelligent Road Studs Lights Colours On A Motorway.jpg

The Shaanxi Yiyuan Traffic Technology Engineering Co.Ltd. 


Tel.png  Tel: +86-29-88270591

Fax.png  Fax: +86-29-88219082

E-mail.png  E-mail: sxyyjt@sx-yyjt.com

QQ.png  QQ: 1829090767

Zip.png  Zip: 710065 

Address.png   Address: No. 5, Production Ro ad, West Thermal Power Plant, West Section Of Hongguang                     Road, Weiyang District , Xi'an,Shaanxi.China 




We're Here to Help

  • Shaanxi Yiyuan Traffic Technology Engineering Co.,Ltd

    Tel: +86-29-88270591

    E-mail: sxyyjt@sx-yyjt.com

    QQ: 1829090767

    Zip: 710065

    Address: No.5, Production Road, West Thermal Power Plant, West Section Of Hongguang Road, Weiyang District, Xi'an, Shaanxi, China

Newsletter

Enter in your email address to receive deals
and coupons.
Bookmark us today!