Home > News > Content
Cast Aluminum Spike Installation Method
Dec 04, 2013

First, protective tools

Cone number, construction diversion card 2 sets, baton, reflective vest one each. Everyone before departure Must wear reflective clothing, to the construction site must be placed good construction license and road cones. Workers must do this: Not joking, not slapstick, obey the command, can not drink 6 hours before the road), each team with 2-4 security staff.

Second, tools

Hammer, Drill (22mm), Pan, Dao Dao, small plastic bucket, chalk, generators, hand drill,

Mixing machine.

Third, the product

All aluminum nails (with nails)

Fourth, supporting materials

Epoxy A, B, cement


cats eye reflector.jpg

Fifth, the installation steps

(1) first with a ruler to determine the installation location, 15m installation of a (in accordance with the drawings installed) guarantee.

Vertical position in a straight line at the same time horizontal alignment, installation distance and design requirements quasi.

(2) (Installation of spiked spike) Drill with a diameter of ∮22mm hammer, the depth of the hole than the spike the nail pin length 10mm. After drilling the hole drilled ash cover clean.

(3) the ratio of glue, glue A and B glue 1: 0.7, and then add 15% -30% of cement as a filler (Glue is not easy to stir too much at once, enough to stick a person 50-70 Spike glue). Colloid to be stirred uniform, (hand drill with mixer) the same color. Each spike tacking requires about 40-50 grams of glue.


eye stud.jpg



(4) the location of the installation road to clean, with about 40-50 grams of approved knife into the drill

Holes and spikes required to install the position, put the spike up, with pressure and turn left and right two under, so that the spike and the road close bond.

(5) after the spike installation, spill around the spike glue, use a knife to scrape clean, and the road clean-up clean.

Sixth, matters needing attention

Hands do not touch the reflector, to avoid glue stick to the reflector, affecting the reflective effect! Pavement there water, dampness and oil are prohibited to install spikes (easy to fall off). Remove the road cone after 4 hours of installation.

cats eye road stud.jpg


The Shaanxi Yiyuan Traffic Technology Engineering Co.Ltd. 


Tel.png  Tel: +86-29-88270591

Fax.png  Fax: +86-29-88219082

E-mail.png  E-mail: sxyyjt@sx-yyjt.com

QQ.png  QQ: 1829090767

Zip.png  Zip: 710065 

Address.png   Address: No. 5, Production Ro ad, West Thermal Power Plant, West Section Of Hongguang                     Road, Weiyang District , Xi'an,Shaanxi.China  


We're Here to Help

  • Shaanxi Yiyuan Traffic Technology Engineering Co.,Ltd

    Tel: +86-29-88270591

    E-mail: sxyyjt@sx-yyjt.com

    QQ: 1829090767

    Zip: 710065

    Address: No.5, Production Road, West Thermal Power Plant, West Section Of Hongguang Road, Weiyang District, Xi'an, Shaanxi, China

Newsletter

Enter in your email address to receive deals
and coupons.
Bookmark us today!